SPACER
WITH DISTRIBUTION BLOCK AND HARDLINES
The
SC500SP-DB-HL
Comes as a complete
kit with fittings, hardlines
and polished spacer that is 1" high
for mounting under the SC500 Sc500-250
and
the SC500-256
series STREETCATCHERS
SPACER
AND DISTRIBUTION BLOCK WITHOUT HARDLINES
The
SC500SP-DB
Comes as pictured (second image down)
without the Stainless steel hardlines
and fittings so you can run either
flexable rubber or flexable stainless
braided hoses
NOTE:
You cannot rob the hardlines off
an old Enderle injector and use them
on this spacer setup, they wont fit.
The drilled positions of the tubes
are different to an Enderle injector.
A change had to be made so that
the hardlines
could be standardised to
fit both the SC500 and SC520 Streetcatcher
Dual
carb
model as well, this needed tube
repositioning to clear the needle
valves on dual sideways setups. |
